WD-40 leaves a residue that attracts dust. This alcohol+oil method flushes oxidation then leaves a clean, thin lubricant film. 7. The "No-Drill" Ground Bus for a Metal Desk The problem: Your station ground needs a common bus bar, but you don’t want to drill into your nice metal desk or filing cabinet.
By WB2FAS (In the spirit of the original QST column) New- Hints and Kinks for the Radio Amateur
Not always, but in a pinch, stranded 18-gauge wire soaked in flux outperforms no wick at all. Keep a 6" piece pre-fluxed in a tiny ziplock bag in your go-kit. 3. The "Eyeglass" SMA Wrench (Free & Perfect) The problem: SMA connectors need to be finger tight plus 1/8 turn . Overtighten, and you’ll snap the center pin or ruin the female receptacle (especially on cheap HTs or SDR dongles). WD-40 leaves a residue that attracts dust
Use a second mat as a soldering iron rest when traveling. The iron tip won’t burn it, and it won’t slide off the table. A Final Word The best kink is the one you discover yourself. Keep a small notebook in your shack (or a digital note) and write down every “that worked well” or “that was stupid, don’t do it again.” The "No-Drill" Ground Bus for a Metal Desk