ETABS doesn't just use "dead load." It calculates mass based on your load combinations. Specifically, for seismic analysis (per ASCE 7, IS 1893, or Eurocode 8), it typically uses:
If you’ve ever run a seismic analysis in ETABS, you’ve probably scrolled past the Mass Summary by Story table. It looks harmless enough—just a few columns of numbers under the Display > Show Tables > Analysis > Results > Structure Output menu.
If you modeled a concrete slab but forgot to assign Self Weight Multiplier = 1 (under ), ETABS will only include the superimposed dead loads (finishes, partitions) and completely ignore the 150 pcf concrete you just modeled. etabs mass summary by story
If you model a semi-rigid diaphragm, ETABS distributes mass to every joint in the slab. If you model a rigid diaphragm, ETABS lumps the entire floor’s mass at the Center of Mass (CM).
Self-weight assignment.
The "Where is my Mass?" Mystery Here is the most common panic moment for engineers: "I assigned a 10-inch slab, beams, columns, and walls... so why does the Mass Summary show almost nothing on the roof?"
In fact, most convergence errors, unexpected mode shapes, and even incorrect base shears can be traced back to a single misunderstood line in this table. ETABS doesn't just use "dead load
Let’s dive into what those numbers actually mean, why ETABS sometimes lies to you (well, not lies , but misleads you), and how to use this table to save your design. In simple terms, the Mass Summary tells you how much weight is pushing down on each level of your building—and more importantly, how that weight moves sideways during an earthquake.