He powered off the M105 and opened the scanner unit. Following a shaky YouTube tutorial, he located the 8-pin EEPROM chip on the printer’s mainboard. He attached the resetter’s clip firmly over the chip. One red LED blinked. He held the button for three seconds. The LED turned green.
Rohan knew the physical pads were still full. The resetter had only tricked the software. He now faced a risk: if the pads truly overflowed, ink would seep into the printer’s base, possibly ruining the power supply or logic board. For the short term—finishing his thesis—it was worth it. For the long term, he cut a piece of absorbent craft felt and slid it under the pad area as a DIY overflow catcher. epson m105 ink pad resetter
The Email That Saved a Printer: An Epson M105 Story He powered off the M105 and opened the scanner unit
He called the authorized service center. The quote made him wince: ₹2,500 for a “pad replacement” and a manual counter reset. Worse, they’d need five working days. Desperate, he stumbled upon a niche forum post: “Epson M105 ink pad resetter – DIY in 5 minutes.” One red LED blinked
It’s a small, standalone electronic device, often no bigger than a USB drive, with a specific chip inside that mimics Epson’s proprietary service interface. Some are software-based, requiring a Windows laptop and a special utility like AdjProg or WICReset . But for the M105, the most common tool is a physical resetter with a wire harness that plugs directly into the printer’s mainboard.
The device doesn’t clean or replace the physical pads. It simply forces the printer’s internal counter back to zero. Epson designs the printer to treat this counter as a hard stop, but a resetter tells the printer: “The pads are new. Carry on.”